Just got a hard drive that uses SATA cords instead of IED. Its all connected but my hard drive isnt showing up on my device manager or my computer.
I went into the SATA Raid Controller and it says the device cannot start (code 10).
When I try to update the drivers it says "The hardware was not installed because the wizard cannot find the necessary software."
Any ideas of how to fix?
Archived topic from Anythingforums, old topic ID:3272, old post ID:59639
Need some help
Need some help
I'm just responding because I didn't want you to feel ignored. Too bad I don't know anything about computers.
Archived topic from Anythingforums, old topic ID:3272, old post ID:59663
Archived topic from Anythingforums, old topic ID:3272, old post ID:59663
Visit Harmony forum
Need some help
yeah... you might want to check and see if the hard drive shows up in your bios first. You can usually view that by hitting f2 or del while your computer is booting up.
Are you trying to set up the drive in a raid? I would think not as you typically use multiple drive of the same configuration for that, and it sounds like you just bought 1 new SATA drive.
I would check the power and data cables on the SATA drive aren't loose.
Archived topic from Anythingforums, old topic ID:3272, old post ID:59668
Are you trying to set up the drive in a raid? I would think not as you typically use multiple drive of the same configuration for that, and it sounds like you just bought 1 new SATA drive.
I would check the power and data cables on the SATA drive aren't loose.
Archived topic from Anythingforums, old topic ID:3272, old post ID:59668
Need some help
also may be a long shot butt also check the jumper's on the drive
Archived topic from Anythingforums, old topic ID:3272, old post ID:60220
Archived topic from Anythingforums, old topic ID:3272, old post ID:60220
growing old is obligatory, but growing up is optional
22/m/nc born in pa
I try to take one day at a time -- but sometimes several days attack me at once.
You'll never find the answer in the bottom of an empty glass. So fill 'er up and keep looking!
An intelligent man is sometimes forced to be drunk to spend time with the a$$hole's he must come in contact with every day."
cash money over everything , money over bitche's
..................................................................................
22/m/nc born in pa
I try to take one day at a time -- but sometimes several days attack me at once.
You'll never find the answer in the bottom of an empty glass. So fill 'er up and keep looking!
An intelligent man is sometimes forced to be drunk to spend time with the a$$hole's he must come in contact with every day."
cash money over everything , money over bitche's
..................................................................................
-
Listerlnx666
- Posts: 69
- Joined: Fri Oct 07, 2005 1:01 pm
Need some help
Pojo_ wrote: Just got a hard drive that uses SATA cords instead of IED. Its all connected but my hard drive isnt showing up on my device manager or my computer.
I went into the SATA Raid Controller and it says the device cannot start (code 10).
When I try to update the drivers it says "The hardware was not installed because the wizard cannot find the necessary software."
Any ideas of how to fix?
if your motherboard's intel then you can find the driver for it on the intel site if you know your chipset, just go there and look for the driver set, it should include the SATA driver.
Archived topic from Anythingforums, old topic ID:3272, old post ID:60255