Anything Forums

My server had a 2700+ running at a decent temp (could only check at 0 load though because my linux version does not support temp monitoring) and my PC was running too hot for my taste... it makes my room too hot, even the A/C can't keep up with the heat in my room.

So I swapped the 2000+ which runs hot with the 2700+. Unfortunatly it's only reconized as a 2100+ but in UD it shows 1.8Ghz and it used to show 1.7 and 1.3 when I had to downclock due to too much heat.

My mobo probably can't handle it at it's fullest that's why. Not sure how cool it runs under 0 load but it's at 44C with full load (UD) so that's pretty good!

Archived topic from Iceteks, old topic ID:2396, old post ID:20231

My PC has a glitch, won't read temp right. After being turned off for 4 days, on bootup it was reading 49C.

Archived topic from Iceteks, old topic ID:2396, old post ID:20302

Weird... unless it really was that hot! But that's rare, usually it takes about 10 minutes for it to go to it's average temp

Archived topic from Iceteks, old topic ID:2396, old post ID:20303

It's a flaw in the mobo that the mfg never corrected.

Archived topic from Iceteks, old topic ID:2396, old post ID:20304

not good service, that!

Archived topic from Iceteks, old topic ID:2396, old post ID:20305

I suppose they didn't get enough complaints about it.

Archived topic from Iceteks, old topic ID:2396, old post ID:20306